GETTING TO KNOW YOUR VEHICLE 69
DEPLOYING THE CROSSBARS
1. Starting with one crossbar, completely loosen the
thumb screws at both ends of the crossbar.
Thumb Screw
NOTE:
The thumb screws cannot be fully removed.
2. Remove the crossbar from the stowed position by
sliding the crossbar towards the center of the roof.
Repeat with the crossbar on the opposite side.
Removing Crossbars
3. Starting with one crossbar, bend down the pivot
supports at each end.
Bending Pivot
4. Position the crossbars across the roof making sure
the letters on the crossbars align with the matching
letters on the side rail.
Positioning Crossbars
CAUTION!
Use care when removing and handling the crossbars to
prevent damage to the vehicle.
2
22_WD_OM_EN_USC_t.book Page 69
To Next Page
Loading...
