GETTING TO KNOW YOUR VEHICLE 49
The Rain Sensing system has protection features for the
wiper blades and arms, and will not operate under the
following conditions:
Low Ambient Temperature — When the ignition is first
placed in the ON position, the Rain Sensing system will
not operate until the wiper switch is moved, vehicle
speed is greater than 3 mph (5 km/h), or the outside
temperature is greater than 32°F (0°C).
Transmission In NEUTRAL Position — When the ignition
is in the ON position, and the gear selector is in
NEUTRAL, the Rain Sensing system will not operate
until the wiper switch is moved, vehicle speed is
greater than 3 mph (5 km/h), or the gear selector is
moved out of NEUTRAL.
REAR WINDOW WIPER/WASHER
The rear wiper/washer controls are located on the
multifunction lever on the left side of the steering column.
The rear wiper/washer is operated by rotating a switch,
located at the middle of the lever.
Rotate the center portion of the lever upward
to the first detent for intermittent operation
and to the second detent for continuous rear
wiper operation.
Rotate the center portion of the lever upward
to the third detent to activate the washer. The
washer will continue to operate as long as the
switch is held.
Rotate the center portion downward from the OFF position
to activate the rear washer. The washer will continue to
operate as long as the switch is held.
NOTE:
As a protective measure, the pump will stop if the switch
is held for more than 20 seconds. Once the switch is
released the pump will resume normal operation.
If the rear wiper is operating when the ignition is placed in
the OFF position, the wiper will automatically return to the
parked position.
CLIMATE CONTROLS
The Climate Control system allows you to regulate the
temperature, air flow, and direction of air circulating
throughout the vehicle. The controls are located on the
touchscreen and on the instrument panel below the radio.
AUTOMATIC CLIMATE CONTROL
D
ESCRIPTIONS AND FUNCTIONS
Uconnect 5/5 NAV With 10.1-inch Display
Temperature Controls
Uconnect 4 With 8.4-inch Display Temperature Controls
Max A/C Button
Press and release the MAX A/C button on the
touchscreen to change the current setting to
the coldest output of air. The MAX A/C
indicator illuminates when MAX A/C is ON.
Performing this function again will cause the
MAX A/C operation to switch into manual mode and the
MAX A/C indicator will turn off.
In MAX A/C, the blower level and mode position can be
adjusted to desired user settings. Pressing other settings
will cause the MAX A/C to exit.
NOTE:
The MAX A/C button is only available on the touchscreen.
A/C Button
Press and release this button on the
touchscreen to change the current setting.
The A/C indicator illuminates when A/C is on.
The Air Conditioning (A/C) button allows the
operator to manually activate or deactivate the air
2
22_WD_OM_EN_USC_t.book Page 49
To Next Page
Loading...
