242 SERVICING AND MAINTENANCE
Bulb Replacement
NOTE:
Lens fogging can occur under certain atmospheric condi-
tions. This will usually clear as atmospheric conditions
change to allow the condensation to change back into a
vapor. Turning the lamps on will usually accelerate the
clearing process.
FRONT TURN SIGNAL
See the following steps to replace:
1. Open the hood.
2. Rotate the turn signal bulb a quarter turn counter-
clockwise to remove from housing.
3. Disconnect the electrical connector and replace the
bulb.
FRONT FOG LAMPS
The front fog lamps are LEDs. See an authorized dealer for
service.
REAR TAIL, STOP AND TURN SIGNAL LAMPS
The rear tail, stop, and turn signal lamps are LED. See an
authorized dealer for replacement.
REAR LIFTGATE MOUNTED BACK-UP LAMPS
See the following steps to replace:
1. Raise the liftgate.
2. Use a fiber stick or flat blade screw driver to pry the
lower trim from the liftgate.
3. Back-up lamps are now visible. Rotate socket(s)
counterclockwise.
Front Fog Lamps LED
Rear Tail Lamps/Side Marker Lamps LED
Rear Stop/Turn Signal Lamps LED
Rear Liftgate Tail Lamps LED
Rear Backup Lamps 921 (W16W)
Rear License Lamps LED
Center High Mounted Stop Lamp (CHMSL) LED
Exterior Bulbs
Bulb Name Bulb Number
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the bulb
comes in contact with an oily surface, clean the bulb
with rubbing alcohol.
22_WD_OM_EN_USC_t.book Page 242
To Next Page
Loading...
