2. Insert the tip of the emergency key or a
#2 flat blade screwdriver into the slot and
gently pry the two halves of the key fob apart.
Make sure not to damage the seal during
removal.
3. Remove the battery by turning the back
cover over (battery facing downward) and
tapping it lightly on a solid surface such as a
table or similar, then replace the battery.
When replacing the battery, match the + sign
on the battery to the + sign on the inside of
the battery clip, located on the back cover.
Avoid touching the new battery with your
fingers. Skin oils may cause battery deterio-
ration. If you touch a battery, clean it with
rubbing alcohol.
4. To assemble the key fob case, snap the two
halves together.
DOOR LOCKS
WARNING!
• Do not touch the exhaust pipe sill covers
when entering or exiting your vehicle. They
can be hot enough to burn you. Observe
the warning labels on each door closure
panel.
(Continued)
WARNING!
(Continued)
• Before exiting a vehicle, always shift the
transmission into NEUTRAL, apply the
parking brake, turn the engine OFF, re-
move the key fob from the ignition and lock
your vehicle. If equipped with Keyless
Enter-N-Go, always make sure the keyless
ignition node is in “OFF” mode, remove the
key fob from the vehicle and lock the
vehicle.
• When leaving the vehicle, always cycle the
ignition to the OFF mode lock, and lock
your vehicle. Unsupervised use of vehicle
equipment may cause severe personal in-
juries and death.
• Never leave children alone in a vehicle.
Leaving unattended children in a vehicle is
dangerous for a number of reasons. A child
or others could be injured seriously or
fatally. Don’t leave the ignition in the ACC
or ON/RUN mode. A child could operate
power windows, other controls, or move
the vehicle.
Power Door Locks
A power door lock switch is on each door trim
panel. Use this switch to lock or unlock the
doors.
Separating Key Fob Case
1 — Emergency Key Release Button
2 — Remove The Emergency Key
Separating The Key Fob Case
13
To Next Page
