CAUTION!
(Continued)
• Accessories that draw higher power (i.e.,
coolers, vacuum cleaners, lights, etc.) will
degrade the battery even more quickly.
Only use these intermittently and with
greater caution.
• After the use of high power draw accesso-
ries, or long periods of the vehicle not
being started (with accessories still
plugged in), the vehicle must be driven a
sufficient length of time to allow the gen-
erator to recharge the vehicle’s battery.
Auxiliary Jumper Harness
The Viper is equipped with an auxiliary power
jumper, allowing an electronic device to be
directly connected to the vehicle without having
to use the console power outlets. Power to the
device will be controlled by the ignition switch.
NOTE:
The electronic device must draw less than
five amps to prevent damage.
To install, remove the mirror cover by pulling
straight down and separating the cover pieces.
Connect the auxiliary port jumper into the un-
used connector taped to the wiring bundle.
Connect the other end of the auxiliary port
jumper to the electronic device.
NOTE:
The red wire in the bundle is the power wire
and will provide the positive 12 volts to the
electronic device.
Re-install the mirror cover and be sure to not
pinch the wires that go into the electronic de-
vice.
CUPHOLDERS — IF EQUIPPED
There are two cupholders located in the rear of
the center console.
Mirror Cover Removal
Auxiliary Port Jumper
Mirror Cover Installation
Center Console Cupholders
58
To Next Page
Loading...
