moved easily with a soft cloth and MOPAR Total
Clean or equivalent. Care should be taken to
avoid soaking the leather with any liquid. Please
do not use polishes, oils, cleaning fluids, sol-
vents, detergents, or ammonia-based cleaners
to clean the leather. Application of a leather
conditioner is not required to maintain the origi-
nal condition.
Glass Surfaces
All glass surfaces should be cleaned on a
regular basis with MOPAR Glass Cleaner, or
any commercial household-type glass cleaner.
Never use an abrasive type cleaner. Use cau-
tion when cleaning the inside rear window
equipped with electric defrosters or windows
equipped with radio antennas. Do not use
scrapers or other sharp instrument that may
scratch the elements.
When cleaning the rear view mirror, spray
cleaner on the towel or cloth that you are using.
Do not spray cleaner directly on the mirror.
Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this
vehicle are molded in clear plastic. When clean-
ing the lenses, care must be taken to avoid
scratching the plastic.
1. Clean with a wet soft cloth. A mild soap
solution may be used, but do not use high
alcohol content or abrasive cleaners. If soap
is used, wipe clean with a clean damp cloth.
2. Dry with a soft cloth.
Seat Belt Maintenance
Do not bleach, dye or clean the belts with
chemical solvents or abrasive cleaners. This will
weaken the fabric. Sun damage can also
weaken the fabric.
If the belts need cleaning, use a mild soap
solution or lukewarm water. Do not remove the
belts from the vehicle to wash them. Dry with a
soft cloth.
Replace the belts if they appear frayed or worn
or if the buckles do not work properly.
NOTE:
If the belts retract slowly, inspect the upper
turning loop for soiling. If soiling is present,
clean with a wet soft cloth until all residue is
removed.
WARNING!
A frayed or torn belt could rip apart in a
collision and leave you with no protection.
Inspect the belt system periodically, checking
for cuts, frays, or loose parts. Damaged parts
must be replaced immediately. Do not disas-
semble or modify the system. Seat belt as-
semblies must be replaced after a collision if
they have been damaged (i.e., bent retractor,
torn webbing, etc.).
Aero Group (Front Splitter) — If Equipped
The front splitter will not flex or compress
against impacts from the front. If an impact does
occur, have the splitter inspected. A cracked or
delaminated splitter should be replaced.
Always leave ample room and be sure to edu-
cate anyone you allow to operate the vehicle.
CAUTION!
Use care when approaching parking blocks,
tall speed bumps and garage curbs. These
surfaces can damage your splitter and fascia.
Use caution when driving up to sloped surfaces
or over speed bumps. Approaching a speed
bump or a slope at a slight angle may improve
your clearance.
Front Splitter
165
To Next Page
