Dogtra iQ plus - How to Fit the Receiver;Collar on the Dog

40 41
3. HOW TO FIT THE RECEIVER/COLLAR
ON THE DOG
The receiver/collar should be tted so that
the surgical stainless steel contact points
press rmly against the dog’s skin. When
properly tted, you should be able to t
a nger or two snugly in between the
contact points and your dog’s skin. When
properly tted, the receiver/collar should
not move on the dog. The best location
for the receiver/collar box is either side of
the dog’s windpipe.
A loose t can allow the receiver/collar
to move around on the dog’s neck. When
this happens, the contact points may
rub the skin and cause irritation. If the
receiver/collar is too tight, the dogs may
have difculty breathing.
3. HOW TO FIT THE RECEIVER/COLLAR ON THE DOG
1-Dog/2-Dog Selector Switch
The 1-Dog/2-Dog switch is to the left of
the Rheostat Intensity Dial.
I – 1-Dog
Slide the switch to the left underneath “I”,
and press any of the buttons to operate the
1st Receiver/Collar.
II – 2-Dog
Slide the switch to the right underneath “II”,
and press any of the buttons to operate the
2nd Receiver/Collar.
2. HOW THE BUTTONS WORK
1-Dog switch
2-Dog switch