Dogtra YS 600 - How to Use the On;Off & Intensity Dial

6
How to Use the On/Off & Intensity Dial
- The On/Off Intensity Dial is used to turn the No Bark Collar
on/off and to select the stimulation intensity level.
- Set the dial to “.” to turn off the No Bark Collar.
- Set the dial to “P” for non-stimulating vibration only mode.
- The No Bark Collar has stimulation levels 1 (lowest) through
10 (highest). Each stimulation level begins with a vibration and
is followed by the stimulation.
- Set the dial to “T” to test the No Bark Collar. See Testing the
YS600 on page 9 to check if your unit is working properly.
NOTICE
When rst using the YS600 No Bark Collar, it is recommended
to start at the lowest stimulation intensity level. If your dog
continues to bark, gradually increase the stimulation intensity
level. Closely monitor you dog’s reaction to nd the right
stimulation level for you dog.
On/O & Intensity Dial Function
• Power O
P Non-Stimulating Vibration
1~10 Stimulation Level
T Test mode