7
The LED Indicator
The LED indicator will ash for 1 second when the YS600
has been turned on, and every 4 seconds afterwards. If your
dog does not bark for over 30 seconds, the LED indicator will
turn off and the YS600 will go into a sleep mode to conserve
battery life. It will reactivate when your dog barks and a
vibration/correction needs to be made.
Before going into Sleep mode, the LED light ashes green
when the battery is fully charged and turns to amber when the
battery life is getting low.
When the LED indicator emits a blinking red light, the battery
needs to be recharged.
Operating Modes
1. Non-Stimulating High Performance Pager (P)
- The YS600 will vibrate twice when your dog barks. It will not
send a stimulation when set to “P”.
2. Stimulation Intensity Levels (1-10)
- The YS600 will vibrate once followed by stimulation when
your dog barks.
* There is a 15 second delay between stimulation on levels
1-10 and vibration on P mode.
Battery life
LED window
Fully charged Medium charge Needs charge
On Working Green Yellow Red
On Charging Green Red Red
To Next Page
Loading...
