Dolmar MS-246.4 U - MACHINE HANDLING AND STARTING; Correct Machine Handling and Attachment; Starting the Engine (Cold Start)

15
CORRECT HANDLING OF MACHINE
Attachment of shoulder strap
– Adjust the strap length so that the cutter blade will be
kept parallel with the ground.
For MS-246.4 U, MS-246.4 UE
NOTE: Be careful not to trap clothing, etc., in the buckle.
Observe the applicable accident prevention regulations!
STARTING
Move at least 3 m away from the place of refuelling. Place the Petrol Brushcutter on a clean piece of ground taking care that the cutting tool
does not come into contact with the ground or any other objects.
A: Cold start
1) Set this machine on a at space.
2) Set the I-O switch (1) to OPERATION.
OPERATION
Lock-off lever
High speed
Low speed
Throttle lever
Hanger
POINTS IN OPERATION AND HOW TO STOP
Detachment
For MS-246.4 C, MS-246.4 CE
– In an emergency, push the notches (1) at both sides, and you can detach the
machine from you.
Be extremely careful to maintain control of the machine at this time. Do not
allow the machine to be deected toward you or anyone in the work vicinity.
WARNING: Failure to maintain complete control of the machine at all could
result in serious bodily injury or DEATH.
For MS-246.4 U, MS-246.4 UE
– In an emergency, push the notches (2) at both sides, and
you can detach the machine from you.
Be extremely careful to maintain control of the machine
at this time. Do not allow the machine to be deected
toward you or anyone in the work vicinity.
WARNING: Failure to maintain complete control of the
machine at all could result in serious bodily
injury or DEATH.
MS-246.4 C
MS-246.4 CE
MS-246.4 U
MS-246.4 UE
STOP
(1)
STOP
OPERATION
Lock-off lever
High speed
Low speed
Throttle lever
(1)
(1)
Buckle
(2)
MS-246.4 U
MS-246.4 UE