Dolmar PS-4605 - User Manual

Questions and Answers

J
jamesgarciaAug 10, 2025
Why my Dolmar PS-4605 Chainsaw engine does not start?
- C
  Christopher AlexanderAug 10, 2025
  If your Dolmar Chainsaw engine does not start or starts with difficulty, this could be due to a malfunction in the fuel supply system, compression system, or a mechanical malfunction. Check and correct the ignition system, ensure the fuel tank is full, and inspect for any malfunctions in the wiring or spark plug. Also, make sure that the combination switch is not in the Choke position and inspect the carburetor and fuel line for any defects or interruptions.
C
Cindy GilbertAug 15, 2025
How to fix insufficient power in my Dolmar Chainsaw?
- V
  Vincent RiosAug 15, 2025
  If your Dolmar Chainsaw is not providing sufficient power, several issues could be the cause. A dirty air filter, incorrect carburetor adjustment, a clogged muffler, a clogged exhaust channel in the cylinder, or a clogged spark arrester screen are all potential culprits. To resolve this, clean or replace the air filter, adjust the carburetor, and unclog the muffler, exhaust channel, and spark arrester screen.
E
esparzajenniferAug 20, 2025
Why is there no chain lubrication in my Dolmar PS-4605 Chainsaw?
- L
  lreidAug 20, 2025
  If your Dolmar Chainsaw chain is not receiving lubrication, the possible reasons are: the oil tank is empty, the oil guide groove is dirty, or the oil pump adjusting screw is incorrectly adjusted. To solve this, fill the oil tank, clean the oil guide groove, and adjust the oil pump adjusting screw correctly.
J
Julia JonesAug 25, 2025
What to do if the Dolmar PS-4605 Chainsaw chain does not run?
- D
  Douglas LeeAug 25, 2025
  If the chain on your Dolmar Chainsaw does not run, it is likely that the chain brake is actuated. To resolve this, release the chain brake.
T
Terrence ColeAug 29, 2025
What to do if my Dolmar Chainsaw engine starts, but dies immediately?
- K
  Karen RogersAug 29, 2025
  If your Dolmar Chainsaw engine starts but dies immediately, the issue could stem from several factors. It might be due to incorrect idling adjustment, or a dirty suction head or carburetor; in this case you should clean these parts and adjust the idling correctly. Other potential causes include defective tank venting, an interrupted fuel line, a defective cable, or a faulty combination switch. Inspect and repair these components to resolve the issue.
M
Michael ThomasSep 4, 2025
How to solve warm start difficulties with Dolmar PS-4605 Chainsaw?
- A
  Ashley ReeseSep 4, 2025
  If you are experiencing warm start difficulties with your Dolmar Chainsaw, it is likely due to an incorrect carburetor adjustment. To resolve this, adjust the carburetor correctly.