EasyManua.ls Logo

Dolmar PS-7310 - User Manual

Dolmar PS-7310
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Operator’s and Safety Manual
for Gasoline Chain Saws (page 2 - 39)
Manuel d’emploi et de sécurité
de tronçonneuses thermiques (page 40- 77)
WARNING!
Read and understand this Manual. Always follow safety precautions in the Operator’s and Safety Manual. Improper use can cause serious injury! Preserve this Manual carefully!
WARNING!
FUELS WITH MORE THAN 10% ETHANOL ARE NOT APPROVED FOR USE IN DOLMAR 2-STROKE ENGINES!
Use of alternative fuels, such as E-20 (20% ethanol), E-85 (85% ethanol) or any fuels not meeting DOLMAR requirements are not approved for use in DOLMAR 2-stroke gasoline engines!
USE OF ALTERNATIVE FUELS CAN CAUSE THE FOLLOWING PROBLEMS:
Poor engine performance, loss of power, overheating, fuel vapor lock, improper clutch engagement, premature deterioration of fuel lines, premature deterioration of gaskets,
premature deterioration of carburetors.
USING ALTERNATIVE FUELS AND/OR 2-STROKE OILS NOT ACCORDING TO JASO FC OR ISO-L-EGD IN DOLMAR 2-STROKE ENGINES WILL VOID YOUR ENGINE WARRANTY!
ATTENTION!
Suivez toujours les conseils de sécurité du présent manuel d’emploi et de sécurité. Une utilisation incorrecte de la tronçonneuse peut entraîner des blessures graves!
Lisez et comprenez ce manuel. Conservez avec soin ce manuel!
ATTENTION!
LES CARBURANTS CONTENANT PLUS DE 10 % D’ÉTHANOL NE SONT PAS AUTORISÉS POUR L’UTILISATION DANS LES MOTEURS 2 TEMPS!
Les carburants alternatifs, tels que E-20 (20 % d‘éthanol), E-85 (85 % d’éthanol) ou tout autre carburant n’étant pas conformes aux exigences DOLMAR ne sont pas autorisés
pour l’utilisation dans les moteurs essence à 2 temps DOLMAR!
L’UTILISATION DE CARBURANTS ALTERNATIFS PEUT CAUSER LES PROBLÈMES SUIVANTS:
Faible performance moteur, Perte de puissance, Surchauffe, Bouchons de vapeur dans la conduite d’essence, Embrayage incorrect, Détérioration prématurée des conduites
d’essence, Détérioration prématurée des joints d’étanchéité, Détérioration prématurée des carburateurs.
L’UTILISATION DE CARBURANTS ALTERNATIFS ET/OU D’HUILES 2 TEMPS NON-CONFORMES À LA NORME JASO FC OU ISO-L-EGD DANS LES MOTEURS À 2 TEMPS
DOLMAR ANNULERA VOTRE GARANTIE MOTEUR!
PS-7310, PS-7310 H
PS-7910, PS-7910 H
PS-7910 XD, PS-7910 HXD
PS-7910 WXD

Table of Contents

Questions and Answers

  • K
    Katelyn MaddoxAug 17, 2025
    Why is my Dolmar Chainsaw not lubricating the chain?
    • R
      reyeskelseyAug 17, 2025
      If your Dolmar Chainsaw isn't lubricating the chain, first check if the oil tank is empty and fill it if necessary. Also, the oil guide groove might be dirty, or the oil pump adjusting screw may be incorrectly adjusted. Clean the oil guide groove and adjust the oil pump.
  • M
    Mark ChenAug 25, 2025
    How to unlock the chain on a Dolmar Chainsaw?
    • K
      Kenneth GonzalezAug 25, 2025
      If the chain on your Dolmar Chainsaw does not run, the chain brake may be actuated. Release the chain brake.
  • A
    April WilsonAug 29, 2025
    What to do if my Dolmar PS-7310 starts then dies?
    • D
      dominguezjenniferAug 29, 2025
      If your Dolmar Chainsaw starts but dies immediately, it could be due to several factors. Check the idling adjustment, and clean or replace the fuel filter and carburetor if they are dirty. Also, the tank venting might be defective, the fuel line interrupted, the cable defective, or the STOP switch defective. Finally, a dirty decompression valve can cause this issue. Repair or replace the tank vent, fuel line, or STOP switch. Clean the decompression valve.
  • W
    Willie WestSep 4, 2025
    How to fix a Dolmar PS-7310 Chainsaw with low power?
    • W
      William StokesSep 4, 2025
      If your Dolmar Chainsaw has insufficient power, the air filter might be dirty. The carburetor adjustment could be wrong, or the muffler, exhaust channel in the cylinder, or spark arrester screen might be clogged. Clean or replace the air filter, adjust the carburetor, and clear any clogs in the muffler, exhaust channel, and spark arrester screen.
  • C
    Caitlyn BenitezNov 10, 2025
    Why won't my Dolmar PS-7310 start?
    • G
      gilbertaaronNov 10, 2025
      There could be several reasons why your Dolmar Chainsaw won't start. It could be a malfunction in the fuel supply, compression, or a mechanical issue. Check the ignition spark, fuel tank, and STOP switch. Other potential causes include a defective wiring, plug cap, or spark plug; a wrongly positioned choke; a defective carburetor; a dirty fuel filter; a bent or interrupted fuel line; a defective cylinder base packing ring or radial shaft packings; defective cylinder or piston rings; a spark plug that doesn't seal; or a broken spring in the starter or broken parts inside the engine. Inspect and repair or replace any defective parts, adjust the choke, clean or replace the carburetor and fuel filter, check the fuel line, ensure proper sealing of the spark plug, and repair or replace the start...

Dolmar PS-7310 Specifications

General IconGeneral
BrandDolmar
ModelPS-7310
CategoryChainsaw
LanguageEnglish

Related product manuals