USER'S MANUAL UNIVERSAL CENTRIFUGE CENTRIC 150
Page 5
3.5 MANUAL OPENING THE COVER
Cover can be opened only when device is powered by mains power. If there is need to open
the cover when power fail, you can do this with special wrench. Push wrench gently trough the hole
near the button and turn button in clockwise direction simultaneously (look figure 2).
figure 2
WARNING: Before manual opening be sure that rotor stops !
4.0 ROTORS AND ACCESSORIES
4.1 ROTOR FIXING
Open the cover and switch off main switch. Put rotor on the motor perch and fix it with
screw. Make this carefully and with appropriate force. Use special wrench delivered in package.
WARNING: Before fixing the rotor on motor perch be sure that all fixing surfaces are
smooth without any damage.
4.2 ROTOR REMOVING
Open the cover and switch off main switch. Remove all accessories from rotor. Unscrew the
screw and remove washer. Put special tool in rotor center and turn it in clockwise direction until
rotor is loosened. Then remove rotor (look at figure 3).
To Next Page
Loading...