Dometic 3316518 Series User Manual

Revision A Form No. 3317464.000 05/22 | ©2022 Dometic Corporation
Programming
Quick Start Guide
THIS QUICK START GUIDE IS INTENDED AS A GUIDE ONLY AND IS NOT INTENDED TO PROVIDE ALL INFORMATION
AND WARNINGS RELATED TO THE PRODUCT. REFER TO YOUR OPERATING AND INSTRUCTION MANUALS FOR
ADDITIONAL IMPORTANT INFORMATION AND WARNINGS, INCLUDING ADDITIONAL SAFETY WARNINGS.
Model For Part Numbers
Power Awning Pro 3316518.XXX, 3316519.XXX, 33117114.XXX, 3317115.XXX, 3316554.XXX, 3316520.XXX
Complete each programming step within four seconds of the previous step to keep the receiver in pairing mode.
Step Operation Audible Alert Awning Movement
1
Turn Power On
Beep x1
None
2
Press Le P2 Button x2
Beep x2
None
3
1
Press Up Button x1
Beep x4
Awning Jogs
4
2
Press Le P2 Button x1
Beep x1
Awning Jogs
5
2
Press Up Button x1
Beep x1
None
6
2
Press Down Button x1
None None
1
When using on 9500 awning, press the DOWN button at step 3 instead of the UP button.
2
Steps 4-7 are only applicable to the 9100 awning series.

Dometic 3316518 Series Specifications

General

Series	3316518
Manufacturer	Dometic
Type	Accessories
Material	Plastic
Color	Black
Category	Accessories
Product Type	Accessories

Summary

Dometic Power Awning Pro Programming

Programming Step 1: Turn Power On

Initiate the programming sequence by turning the power on.

Programming Step 2: Left P2 Button Press

Press the Left P2 button twice to proceed with programming.

Programming Step 3: Up Button Press

Press the Up button once to trigger awning jogs.

Programming Step 4: Left P2 Button Press

Press the Left P2 button once for awning jogs.

Programming Step 5: Up Button Press

Press the Up button once to initiate awning jogs.

Programming Step 6: Down Button Press

Press the Down button once to continue programming.

Programming Step 7: Left P2 Button Press

Press the Left P2 button once for awning jogs.

Programming Step 8: Set Sensor Dial to Zero

Set the sensor dial to "0" for programming.

Programming Step 9: Left P2 Button Press

Press the Left P2 button once to engage awning jogs.

Programming Step 10: Left P2 Button Press

Press the Left P2 button once; no awning movement expected.

Programming Step 11: Programming Button Press

Press the Programming Button once or five times.

Programming Step 12: Set Sensor Dial to Five

Set the sensor dial to "5" for awning retraction.

Programming Step 13: Programming Button Press

Press the Programming Button once to retract the awning.

Programming Step 14: Set Sensor to Desired Level

Adjust sensor sensitivity without reprogramming.