BordBar TB08 Troubleshooting
13
9 Troubleshooting
Problem Possible cause Suggested remedy
Your cooler is not
working and the fan
wheel which can be
seen from the outside is
not turning.
No voltage is flowing
from the cigarette
lighter in your vehicle.
The ignition must be switched on in most
vehicles to supply current to the cigarette
lighter.
The ignition is on and
the cooler is not
working.
Pull the plug out of the
socket immediately and
make the following
inspections.
The cigarette lighter
socket is dirty. This
results in a poor
electrical contact.
Clean the socket of the cigarette lighter
with a non-metallic brush and a solvent,
to ensure that the middle contact pin is
clean. If the plug of your cooler becomes
very warm in the cigarette lighter socket,
either the socket must be cleaned or the
plug has not been assembled correctly.
The fuse of the
connection cable has
blown.
Replace the connection cable fuse (5 A).
The vehicle fuse has
blown.
Replace the vehicle cigarette lighter fuse
(usually 15 A). Please refer to the
operating manual of your vehicle.
Your cooler does not
cool satisfactorily and
the outer fan wheel is
not turning.
The fan motor is
defective.
This can only be repaired by an author-
ised repair centre.
The cooler does not
cool satisfactorily and
the outer fan wheel is
turning.
The fan motor for the
inner fan is defective.
This can only be repaired by an author-
ised repair centre.
The Peltier element is
defective.
The integrated mains
adapter is defective.
This can only be repaired by an author-
ised repair centre.
TB08_OPM_EMEA16.book Seite 13 Mittwoch, 19. Juni 2019 8:53 20
To Next Page
Loading...
