CFX Operation
17
I
2. Connect the cooling box, see chapter “Connecting the cooling box” on
page 14.
A
3. Press the “ON/OFF” button (fig. 3 1, page 3) for between one and two
seconds.
✔ The LED “P” lights up (fig. 3 2, page 3).
✔ The display (fig. 3 5, page 3) switches on and shows the current temperature.
I
✔ The cooling box starts cooling the interior.
I
Latching the cooling box lid
1. Close the lid.
2. Press the latch (fig. 2 1, page 3) down, until it latches in place audibly.
I
NOTE
Place the cooling box as shown (fig. 1, page 3). If you operate the box
in a different orientation it can be damaged.
NOTICE! Hazard from excessively low temperature
Ensure that the only those objects are placed in the cooling box that are
intended to be cooled at the selected temperature.
NOTE – Displayed temperature
The temperature displayed is that of the large interior compartment
(CFX50: fig. 7 1, page 5).
NOTE
When operating with the battery, the display switches off automatically
if the battery voltage is low. The LED “P” flashes orange.
NOTE – Alarm “Lid open”
If the lid is left open for three minutes or more and the device is switched
on, the interior light will flash until the lid is closed.
DometicCFX28-CFX50_OPM_4445103579_EMEA16_202x-xx-xx.book Seite 17 Dienstag, 28. September 2021 4:09 16
To Next Page
Loading...
