DC-Kit2 Using the DC kit
21
8.1 Switching on the system
Observe the following instructions before you switch on the system:
• Air the vehicle.
• Make sure that the ventilation slots on the air nozzles and the fan of the
components are not covered up.
• Make sure that all the housings and cables are not damaged and that all the
insulation is intact.
• Compare the existing supply voltage with the technical data.
• Do not insert any fingers or objects into component openings.
I
Stationary mode: 230 Vw mains operation
The system is supplied with 230 Vw from the mains. Leave the inverter switched off.
The socket on the inverter supplies electricity.
Driving mode: power supply from the 12 V battery
➤ Switch on the inverter using the remote control.
A
➤ Use the roof air conditioner as described in the operating manual.
NOTE
CA2500, B2200, B1600 Plus, FJ1100, FJ1700, FJ2200, FL1600,
FL2200: the remote control for the roof air conditioner can only be
used if the air conditioning is supplied with 230 V mains network or with
the inverter.
NOTICE!
CA2500, B2200, B1600 Plus, FJ1100, FJ1700, FJ2200, FL1600,
FL2200: the inverter may be damaged.
Do not switch on the roof air conditioner in the automatic or heating
modes.
DC-Kit2--IO-16s.book Seite 21 Dienstag, 21. März 2017 2:15 14
To Next Page
Loading...
