- 24 -
INSTALLATION PROCEDURE
DOOR PANEL INSTALLATION CONT'D
RM3762 & RM3962
To install the door panels, follow these steps:
1. Remove the decoration strip by inserting a nger in
the plastic prole and pull.
2. Open the door 90 degrees.
3. Insert the door panel’s edges into the grooves of the
door frame. Push the panel sideways until the edge
of the panel is tted into the opposite side groove.
4. Snap on the decoration strip.
1 2
5. Snap on the handle.
REPLACING THE DOOR PANELS
To replace a mounted door panel, follow these steps:
1. Detach the handle by using a at blade screwdriver
to gently push the two tabs away.
2. Remove decoration strip and door panel.
3. Install the new panel according to the previous
instruction, steps 3-5.
To Next Page
Loading...
Need help?
General
