Dometic DMR 7-Series - Appendix E - Maintenance Schedule

- 26 -


Customer Name: Model No.: Date of Purchase:
Address: Serial No.:
State:City: Zip Code:
Phone:
FIRST YEAR
Date:
Dealership:
Address:
City:
State: Zip:
Phone:
Technician:
Cleaned Burner Assembly: Yes / No
Cleaned/Check All Terminals Connections: Yes / No
Cleaned/Inspect All Ground Connections: Yes / No
Inspect and Test Door Seals: Yes / No
Inspect and Tighten LP Lines: Yes / No
Power Ventilator Installed: Yes / No
*Gas Safety Shutdown in 45 seconds: Yes / No
ACTUAL SPEC. RANGE
Electrode Gap 3/16"
Thermister Reading 7-10,000 ohms @ 32°
*D/C Voltage 9.5 to 15 volts D/C
*A/C Voltage 120 Volts ± 10%
Thermocouple Reading 25-35 Millivolts
*Delay Between Modes Approx. 5 seconds
* Use PAL RV Diagnostic Tool for these tests.
ICEMAKER MODELS
Inspect Water Valve and All Connections: Yes / No
Inspect Heat Tape Switch for Proper
Operation: Yes / No
SECOND YEAR
Date:
Dealership:
Address:
City:
State: Zip:
Phone:
Technician:
Cleaned Burner Assembly: Yes / No
Cleaned/Check All Terminals Connections: Yes / No
Cleaned/Inspect All Ground Connections: Yes / No
Inspect and Test Door Seals: Yes / No
Inspect and Tighten LP Lines: Yes / No
Power Ventilator Installed: Yes / No
*Gas Safety Shutdown in 45 seconds: Yes / No
ACTUAL SPEC. RANGE
Electrode Gap 3/16"
Thermister Reading 7-10,000 ohms @ 32°
*D/C Voltage 9.5 to 15 volts D/C
*A/C Voltage 120 Volts ± 10%
Thermocouple Reading 25-35 Millivolts
*Delay Between Modes Approx. 5 seconds
* Use PAL RV Diagnostic Tool for these tests.
ICEMAKER MODELS
Inspect Water Valve and All Connections: Yes / No
Inspect Heat Tape Switch for Proper
Operation: Yes / No