ENGLISH
Eskimo Ice Systems
6
Programmable Parameter Table
No Description Default Range
P-1
t-1 High Pressure Restart Delay 0 0 - 30 minutes
t-2 Low AC Line Voltage off 75-100 or 175-200
t-3 CAN ID n/a 1-254
t-4 Group ID 5 1-254
t-5 Reset Programmable Parameters 0 0 = No, 1 = Yes
Figure 1. Programmable Parameter Table
t-3: CAN ID: Used to set CAN bus ID. The range is from
1-254.
t-4: Group ID: Used to set CAN bus ID. The range is
from 1-254.
t-5: Reset Programmable Parameters: Resets
all programmable parameters to factory defaults. Set this
setting to 1 and unit will reset all values. Setting will change
back to 0 on exit of the programming mode or by pressing
the On/Off button to scroll through parameters.
Note: Changes to technical parameters not listed
above should be performed by an authorized service
dealer. Please contact Dometic at 800-542-2477 for a
dealer near you.
To Next Page
Loading...
