6
Securing
Connecting the Device to the Electricity Supply
The device must be connected to a properly earthed
socket in line with the relevant valid country
regulations.
The mains plug/socket must be freely accessible.
Check prior to initial operation that the voltage
noted on the model label corresponds to the
mains voltage.
If this is not the case, do not connect the
device and contact your dealer!
If the connection cable is damaged it must be replaced by the Customer
Service at Dometic, or by respectively qualified personnel, in order to pre-
vent any hazards.
4.6
4.7
Drive in the screws and place the caps
on.
When being built into a cupboard or
a recess, the miniBar must be posi-
tioned in such a manner that both
hinges/feet of the unit lie flush.
The miniBar is then (see Figures a,
b) screwed, at its hinges, to the
piece of furniture in question.
In the case of units with 8mm feet
and with LED option for the door
opening control, the reflector deli-
vered with the unit must also be
installed in the manner shown in
Figure a.
Stick on
supplied reflector., ...
To Next Page
Loading...
