Intended use KTGsmartCI2.0
12
3 Intended use
KTG smartCI 2.0 is a system for the central monitoring and control of CI BUS-based
vehicle technology in recreational vehicles.
4 Technical description
KTG smartCI 2.0 consists of a central control unit for 12 V consumer units and acces-
sories such as a 12 V distributor, a lighting control unit, an air conditioner or a
charger. The control unit is operated using three sensor buttons and a touchscreen.
The touchscreen is also used to display information for the status indicators.
CI BUS-based vehicle technology sends information and receives operator and
control commands.
You can find the exact number of supported devices on the KTG website:
Temperature sensors
Up to 3 battery sensors
CI BUS-capable battery chargers
Air conditioner
Heating system
Fresh water and gray water tanks (with fill level alarm)
Electric front shade
Via “Quick Mode” you can save and access two presets each for your favorite light-
ing, air conditioning and heating settings. Day and night mode influence all of the
above mentioned presets, plus the fan shut-off for active CI BUS-capable chargers.
The predefined 12 V consumer unit and the lighting control unit can be switched on
and off via the main switch.
The software for the system control is updated using a microSD card.
.7*VPDUW&,2VERRN6HLWH'RQQHUVWDJ-DQXDU
To Next Page
Loading...
Need help?
General
