8
Dometic 8700 Series MasterFlush ToiletInstallation
5.3 Toilet system with wall touchpad and through-the-floor connections
- all applications
1. Place oor mounting template in desired location (g.
8
). For optimal user comfort, make sure
walls or other interior xtures are at least 11 in. (279 mm) away from centerline of template.
2. Center punch all holes through template.
3. Remove template from oor. Drill all access holes as indicated on template (g.
9
).
4. Plan ush switch panel and electronic control module locations so that electrical connections can
be made with cables provided. Be sure module and wires cannot get wet.
5. Use Dometic wall switch template to mark location of fastener and access holes. Drill 1 in.
(25 mm) hole, then fasten panel bracket to wall (g.
10
).
6. Route Dometic ush switch panel cable (g.
1
E
, p. 2) from ethernet connector on control
module to access hole at ush switch panel location. Attach cable to Dometic DFT ush switch
panel, then snap the panel cover onto the panel bracket (g.
10
).
7. Install control module in cool, dry location, then attach Dometic ush switch cable to ethernet
connector on control module (g.
11
).
8. With electrical power off, complete wiring connections to control module. Refer to wiring diagram
printed with parts list (packed separately).
9. Route 4-wire control module cable (g.
1
D, page 2) to toilet through access hole in oor.
10. Route water supply and discharge plumbing to toilet according to system requirements (Section
4.2). Make sure to provide extra discharge hose length to assure easy connection to toilet
(g.
12
, page 9).
8
9
10
Note
When installing Vimar or Gewiss ush switch/status panel,
disregard instructions for installing Dometic touchpad switch.
Install Vimar or Gewiss component on wall according to
manufacturer’s instructions, then attach end of cable to 6-wire
connector (g.
1
D, page 2) at control module.
11
To Next Page
Loading...
Need help?
General