7
INSTRUCTIONS FOR USE
EXTREME COLD WEATHER
OPERATION
Refrigerator performance may be reduced in extremely
cold (subzero) temperatures. This temporary condition is
normal for absorption refrigerators and does not indicate
product failure. In the event that performance is reduced
in such conditions, turn the refrigerator off. As ambient
temperatures rise, please restart your refrigerator accord-
ing to instructions before requesting service.
CLIMATE CONTROL SYSTEM
NDM1062
During the summer months of high temperature and
humidity, the metal frame between the freezer and fresh
food compartments may have water droplets forming. The
number of water droplets will increase if the vehicle is not air
conditioned during these months. The refrigerator comes
standard with a 12 VDC climate control that will evaporate
the water droplets when they form. The climate control can
be left on continuously or used only when temperatures
require it. Note that when turned on, the climate control
will draw 12 VDC power continuously. Turn it off when a
charging source is not available.
1. Turn the climate control switch to I (ON).
2. Press the CLC button. The indicator lamp will
illuminate.
ON
OFF
AC
GAS
CHECK
AES
AUTO
COLD
1
2
3
4
5
COLDEST CLC
LAC
The Climate control
switch is located be-
neath the top decora-
tion panel that houses
the control panel.
OPERATING THE ICE MAKER
(ICE MAKER MODELS ONLY)
Before the ice maker can operate, make sure that:
• The refrigerator is connected to 120 VAC .
• The water valve supplying the refrigerator is turned on.
• The ice level bail arm is in its fully down position.
Keep bail arm in the up (OFF) posi-
tion until water is present at the ice maker.
When the ice maker thermostat senses the preset tempera-
ture for the ejection of the ice cubes, the ngers will start to
rotate, dumping any ice cubes and lling the mold with water.
When the storage container is full, the bail arm will come
in contact with the ice cubes. The bail arm cannot return
to the full down position and the ice production is stopped
until the bin is emptied, or ice cubes are removed.
To prevent water from splashing out of the mold assembly
while travelling in your recreational vehicle, raise the bail
arm to the full UP/OFF position about 1-1/2 hours before
departing. This will allow the water in the mold to freeze.
WATER SUPPLY
The water supply system must have a minimum pressure
of 15 pounds per square inch gauge (psig). A 1/4” diame-
ter water line to the water valve should be used at the rear
of the refrigerator. The water line must have a manual
shutoff valve placed where it is easily accessible.
The maximum water level is represented by a thin line. It
is essential that the water level does not exceed this line!
If necessary,change the water ow by adjusting the water
supply. For instructions, see ADJUSTING THE SIZE OF
CUBES.
Maximum
water level
Ice level
bail arm
Down
position
To Next Page
Loading...
Need help?
General
