- 8 -
The gas supply system must incorporate a pressure regulator
to maintain a supply pressure of not more than 11 inches water
column. When testing the gas supply system at test pressures:
must be disconnected from the gas supply piping system.
- the appliance must be isolated from the gas
-
If detailed instructions on the installation and connection to
the gas supply are required, please contact your dealer or
distributor.
Testing LP gas safety shut off
The gas safety shut off must be tested after the refrigerator is
Rm2354, Rm2454, Rm2554, Dm2662, Dm2663,
Dm2862, Dm3862, nDm1062 & nDR1292
To test the gas safety shut off, follow these steps:
Start the refrigerator. Switch to GAS mode.
indicator lamp is on.
refrigerator.
lamp should be lit and the GAS mode indicator lamp
should be off.
any button positions on the control panel.
rinse it with fresh water. Be careful not to damage the
-
mal operation of the burner should return.
minutes.
Rm2351, Rm2451, Rm2551, Dm2652 & Dm2852
To test the gas safety shut off, follow these steps:
Start the refrigerator without connecting to
120V AC.
1.
2.
3.
4.
5.
6.
8.
9.
10.
11.
1.
2.
3.
DRain wateR hose
hose is long enough in order for the water to drain outside of
length of hose.
connections
Gas connection
-
installation instRuctions
Drill the hole in the cut out
opening of the base plate
To Next Page
Loading...
Need help?
General
