Dometic Penguin II - Preparing to Work Inside the RV; Installation; Installing the Foam Dividers

15
EN
Value Air Distribution Box (ADB), Mechanical Installation
4. Li and place the rooop component over
the prepared opening using the gasket on the
rooop component as a guide.
I
The outside work is complete. Minor adjustments
can be made from inside the RV if required.
6.5 Preparing to Work Inside the RV
This section describes the interior preparation.
1. Bring the ADB kit inside the RV. The box contains the
mounting hardware for the ADB that will be used
inside the RV.
q
18 Centering the Rooop Model Unit from Inside the RV
q
Roof Gasket
2. From inside the RV, check the gasket alignment of
the rooop component over the roof opening. If
necessary, adjust the rooop component from below
by slightly pushing up.
q
w
19 Return Air Opening
q
Electrical Cord
w
Ceiling Thickness
3. Reach up into the return air opening of the
rooop component and pull the rooop component
electrical cord down for later connection.
4. Remove the ADB and the mounting hardware from
the carton. See “ADB Components” on page4
for the parts configuration.
7 Installation
7.1 Installing the Foam Dividers
Roof thicknesses vary among RVs and the ADB
installation may require additional foam to fill any gaps in
thicker roofs.
This section describes how to determine if additional
foam dividers are required, the number required, and
the installation method.
w
q
e
20 Measuring the Roof Thickness for Foam Divider Installation
q
Ceiling Opening
e
Roof Thickness
w
Rooop Model Unit
Basepan
1. Measure the roof thickness, from a flat surface of the
installed rooop component’s basepan to the ceiling
opening inside the RV.