Dometic ProSafe MD408 - Page 17

EN
Using the safe proSafe
18
8.5 Reading the memory (Audit)
I
The safe has a permanent memory which records the last 1000 events.
Transferring data to an SD card
➤ Insert an SD card (fig. 5 1, page 4) into the SD card reader (fig. 5 2, page 4)
(not included in scope of delivery).
➤ Remove the screw on the cover (fig. 6 1, page 4).
➤ Take off the two covers.
➤ Connect the SD card reader device to the slot on the circuit board (fig. 5 3,
page 4).
➤ Press the ENTER button twice.
➤ Enter the code: 0141497167
➤ Press the ENTER button.
✓ The display shows the message DATE.
➤ Enter the date in the format dd/mm/yy.
✓ The display shows the message HOUR.
➤ Enter the time in the format hh/mm.
✓ The display shows the message ROOM.
➤ Enter the lock number (e.g room number).
➤ Press the ENTER button.
✓ The transfer of data to the SD card begins.
✓ The data transfer is complete when the display goes out and three acoustic
signals sound.
NOTE
• You require access to the Internet to use the audit function.
• You must be registered on the internet at
www.sam.dometic.com.
MD-IO-16s.book Seite 18 Freitag, 4. August 2017 9:25 09