Cleaning and maintenance RH418NTE, RH418NTEG
20
6.8 Using the automatic door control (optional)
The automatic door control (optional) displays via an LED (fig. 1 3, page 3) that the
door has been opened.
If the door opening monitor LED is lit:
1. Open the cooling device.
2. If necessary, refill the cooling device.
3. Reset the door control monitor with the remote control (optional).
– Hold the remote control towards the door opening sensor (fig. 1 1,
page 3).
– Press the red button once (fig. 2 1, page 3).
4. Close the cooling device.
6.9 Defrosting the cooling device
The cooling device is equipped with an auto-defrost function.
7 Cleaning and maintenance
!
A
1. Use a soft cloth, lukewarm water and a mild detergent to clean the inside of the
cooling device.
2. Wash out the cooling device using clean water and dry thoroughly.
3. At annual intervals, remove dust from the cooling aggregate at the back of the
cooling device using a brush or a soft cloth.
WARNING! Electrocution hazard
Always disconnect the device from the power supply before you clean
and service it.
NOTICE! Damage hazard
• Never clean the cooling device under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooling device.
To Next Page
Loading...
