Donaldson Torit Unimaster UMA 100 User Manual

Installation
and Operation Manual
IOM AD3547701
Revision 1
Unimaster
®
Dust Collector
Models UMA 40, 70, 100, 150, and 250
built after August 2005
Models UMA 450 and 750
built after March 2006
Throughout this manual
statements indicating
precautions necessary
to avoid equipment failure are
referenced in a Note. Statements
indicating potential hazards that
could result in personal injury or
property damage are referenced
in a Caution! box.
Installation,
Operation, and
Service Information
This manual is property of the owner. Leave with the unit when set-up and
start-up are complete. Donaldson Company reserves the right to change design
and specifications without prior notice.
UMA-H 250
Hopper Base
UMA-B 250
Bin Base
UMA-D 250
55-Gallon Drum Base

Donaldson Torit Unimaster UMA 100 Specifications

General

Number of Filters	1
Filter Area	100 sq ft
Motor Power	1.5 HP
Inlet Size	8 inches
Outlet Size	8 inches

Summary

Operation

Unit Operation

Details the normal operation and filter cleaning cycles of the unit.

Installation Codes and Procedures

Electrical Wiring

Rigging Instructions

Procedures and safety precautions for lifting and moving the unit.

Hoisting Information

Details on using lifting points, connectors, and spreader bars.

Standard Equipment and Unit Installation

Unit Installation (UMA-B 40 to 150)

Steps for installing UMA-B 40 to 150 models, including foundation prep.

UMA-H Installation

UMA-B 250 to 750, UMA-D, or Two-Piece Shipments Installation

Electrical Connection and UMA Controller

UMA Controller Operation

Start Function

Clean Function

Magnehelic Gauge

Installation and Setup

Service and Maintenance

Preliminary Start-Up Check

Filter Management

Filter Removal

Step-by-step instructions for safely removing filter inserts and bags.

Filter Replacement

Detailed guide for installing new filter bags and inserts correctly.

Troubleshooting

Common Issues and Remedies

Lists common problems with probable causes and solutions.