Donco kids 795 User Manual

Fort Worth, Texas 76140
795 3 DRAWERS CHEST
LOUVER
ASSEMBLY INSTRUCTIONS
Thank you for purchasing this quality product. Be sure to check all packing
material carefully for small parts which may have come loose inside the
carton during shipment. Separate, identify and count all parts and hardware.
Compare with the parts list to be sure all parts are present.
"DO NOT TIGHTEN SCREWS UNTIL COMPLETELY ASSEMBLED"
IMPORTANT:
PLEASE READ INSTRUCTION BEFORE STARTING THE ASSEMBLY
* Use of power tool to assemble this
product will invalidate any claim and
damage this product making unsafe !!!
* Please assemble on a clean soft
surface to avoid damage.
!
Tools Required
(Not included)
+
0:45 h
1
2
3
4
5
6
7
8
9
10
11
12
(Not included)

Donco kids 795 Specifications

General

Brand	Donco kids
Model	795
Category	Indoor Furnishing
Language	English

Summary

Product Overview and Preparation

Tools Required

List of tools necessary for assembling the Donco Kids chest, including screwdriver and hex screwdriver.

Important Assembly Precautions

Key instructions like not fully tightening screws until assembly is complete and reading instructions beforehand.

Parts Identification

Hardware Identification Guide

Visual guide to identify all hardware components, including screws, dowels, and knobs, with their quantities.

Main Unit Assembly Steps

Step 01: Attaching Dowels and Panels

Connect main structural panels using wood dowels and screws for initial frame setup.

Step 02: Assembling the Main Frame

Connect side panels and back support rails, identifying TOP, BOTTOM, and BACK orientations.

Completing the Main Unit

Step 03: Securing Frame Components

Continue reinforcing the main unit structure by attaching side panels to the base.

Step 04: Attaching the Back Panel

Install the back panel using specified screws to complete the main cabinet structure.

Drawer Assembly

Step 05: Assembling Drawer Sides and Base

Construct the sides and base of the three drawers using screws.

Step 06: Attaching Drawer Fronts

Secure the drawer fronts to the assembled drawer boxes.

Step 07: Installing Drawer Knobs

Attach the metal knobs to the drawer fronts using screws.

Final Assembly and Adjustments

Step 08: Inserting Drawers and Adjusting Slides

Place assembled drawers into the unit and adjust slide mechanisms for proper alignment and movement.