Donner MAMP5 - Speaker Setup and Audio Input; System Sound Field Positioning; Speaker Output Connections

6.EN
English
System sound field positioning
Please use a short regular speaker cable to connect the speaker output and the input of each speaker.
If not properly connected, the speaker will not sound. Please make sure that the "+" wire of the amplifier
is connected to the "+" terminal of the speaker, and the "-" wire of the amplifier is connected to the "-"
terminal of the speaker. If reversed, the sound will be unnatural and there will be no low-frequency.
Speaker output connections
AUDIO OUTPUT
CH.B CH.A
CH.B CH.A
AUDIO OUTPUT
CH.D CH.C
CH.D CH.C
AC115V/60H z 6A
POWER INPUT
AC230V/50 Hz 4 A
Model:
Peak power:
Frequency response:
Input: AC~115/ -230V/5060Hz Hz
Pro duct:
Amp lifie r
MAMP5
440W
20Hz-20KHz
Connection of speaker cable
1: First, The speaker cable
shall be reserved with copper
wire of at least 6 mm long.
6 mm
2: Then insert all the copper
wires into the connector.
L
R
R
L
L
R
Left channel speakers
Right channel speakers