8
If the
machine
reaches 99% and you feel that the soft serve is not as firm
or as thick as you would like, then you can
make
a quick
adjustment
to
the Firmness
Setting
on your D600. This setting can be adjusted
while
the
machine
is in “Ready Mode” or “Auto
Mode
”.
1. Press & Hold the “UP” or “DOWN” button on the control panel of the D600
until the word “SET” begins to flash on the display screen.
2. The flashing number below “SET” on the display screen is the current
firmness setting. This number can range between 1-10. 1 being the least
firm and 10 being the firmest setting.
3. Press the up or down button again change the setting as needed.
NOTE:
It
is recommended changing this setting 1 step at a
time.
4. Once you have reached the setting you would like the machine to be set
at, press the “SET” button and the setting will be saved.
5. When you are done with your using your Soft Serve machine, press the
“STOP” button then the compressor and drive motor will shut off.
To Next Page
Loading...
