dooch Q-Drive NQ-0220-T - Description on Function of Parameter Settings; Pump Control Group

[CHAPTER 6 FUNCTION TABLE & DESCRIPTION]
6-6 | DOOCHPUMP
6-4. Description on Functions of Parameter Settings
6-4-1 Pump Control Group
Pr-00 Jump Code
ㆍ It allows moving to desired code number directly.
ㆍ It is also possible to move to other code using key after moving.
Pr-01 Pump Capacity
ㆍTo set up and confirm pump capacity.
ㆍInitial value is automatically set by drive capacity.
Related Functions
dr-10 Capacity of Motor
dr-11 No. of Poles of Motor
dr-12 Rated Current of Motor
dr-13 Rated Rotations of Motor
dr-14 Rated Voltage of Motor
dr-15 No-load Current of Motor
dr-16 Rated Slip Frequency of Motor
dr-17 Rated Frequency of Motor
dr-18 Efficiency of Motor
Pr-02 Pump Control Mode
ㆍ To set up pump control method.
Setup Data Functional Description Related Functions
Pr-03,
Capacity of
Sensor 1
Pr-04
Correction of
Sensor 1
Discharge
Direction
Pr-05
Capacity of
Sensor 2
0
Differential Pressure
Control Method
Pr-06
Correction of
Sensor 2
Suction
Direction
Pr-03 Capacity of Sensor 1
1
Constant Pressure
Control Method (Factory
Setting)
Pr-04 Correction of Sensor 1