[CHAPTER 6 FUNCTION TABLE & DESCRIPTION]
6-20 |
DOOCHPUMP
dr-37 No. of Auto Restart after Trip
ㆍ It refers to No. of automatic operations for drive after occurrence of trip.
If the trip occurs more than specified number, it can not restart.
ㆍ If there is no trip during certain time, No of trip might be deleted.
ㆍ It may not be restarted according to error code. Refer to Chapter 7 Fault History Table.
Factory Setting Input Range
0~50[times]3[times]
dr-38 Automatic Restart Waiting Time after Trip
ㆍ When a specified time elapsed after trip, it restarts.
Factory Setting Input Range
0~250[sec]10[sec]
dr-40 Drive Control Mode
ㆍ It selects V/F control or slip compensation control.
V/F control refers to a control to make ratio of output voltage and output frequency constant,
while slip compensation control makes motor speed regular with slip compensation function.
Setup Data
Functional
Description
Related Function
0 (Factory Setting) V/F control dr-41 Torque boost amount
dr-10 Motor capacity
dr-12 Rated current of motor
dr-15
Non-load current of
motor
dr-16 Rated slip of motor
1
Slip Compensation
Control
dr-18 Efficiency of motor
dr-35 Motor Overheat Selection
ㆍ It sets motor overheat protection function.
The drive calculates load current of motor by itself and determines overheat by expecting
increase of temperature.
Setup Data Functional Description
esaeleR )gnitteS yrotcaF( 0
puteS 1
dr-36 Ground Detection
ㆍ It sets ground protection function.
Setup Data Functional Description
esaeleR )gnitteS yrotcaF( 0
puteS 1
To Next Page
Loading...
