3. SAFETY RULES
The improper use is not allowed.
Provide good lighting and visibility when operating the dock leveler.
When operating the dock leveler, keep the operating zone free from people and obstacles.
Watch closely when handling outsized, unstable or dangerous loads, and when the operating zone is not
free from obstacles.
When operating the dock leveler, be sure that the door is fully opened.
Make sure that the truck has stopped in the required position. If there is a risk of truck departure fix it using
a wheel block.
Before loading/unloading, make sure that the dock leveller lip lies in the truck body correctly. The lip must
overlap the truck bed by at least 85 mm.
The dock leveller control unit must be placed so that the operator has full view of the operating zone and is
able always to keep under control the whole process of loading/unloading.
To prevent injury during installation, keep a safe distance from the dock leveller.
Before connecting any wire be sure that the power supply is switched off.
When not in use, the dock leveller should be in the closed position.
Do not put the lip of dock leveller on the truck’s tail lift.
Do not exceed the maximum allowable working angle 12.5% or 7°.
FUNCTION
Function DCUT-1 DCUT-2 DCUT-3
Impulse AUTO button
zz
400Volt
zzz
Traffic light outside
zz
Traffic light inside
zz
Dock light
zz
Interlock (door-dockleveler)
zzz
Extra safety devices connection
zz
Service indicator
zz
Digital display
zz
Door control
z
Inflatable dock shelter control
z
SAFETY RULES
To Next Page
Loading...
Need help?
General