To Next PageTo Next PageHow to fix a DoorHan SECTIONAL-1000PRO-CE Gate Opener when it does not run?
If your DoorHan Gate Opener isn't running, the issue could be due to no power supply or a blown fuse. Make sure the power is on and replace the fuse if necessary.
What to do if the DoorHan SECTIONAL-1000PRO-CE Gate Opener remote control does not run?
If your DoorHan Gate Opener remote control isn't working, it might not be recorded in the receiver memory, or the battery could be dead. Try recording the remote control again or changing the battery.
Why is the DoorHan Gate Opener remote control actuation distance too small?
If the remote control actuation distance is too small for your DoorHan Gate Opener, the battery may be discharged or there may be an interfering signal. Try changing the battery or removing the source of interference.
How to reduce noise when DoorHan SECTIONAL-1000PRO-CE Gate Opener runs?
If your DoorHan Gate Opener is noisy when it runs, the chain might not be properly lubricated. Lubricate the chain to reduce the noise.
What to do if the DoorHan SECTIONAL-1000PRO-CE chain moves but the door doesn't?
If the chain is moving but the door isn't, the carriage may be disengaged or not hooked with the chain support. Engage the carriage or hook it with the chain support.
What does it mean when my DoorHan SECTIONAL-1000PRO-CE Gate Opener beeps twice, the door doesn't move, and the display blinks 'P'?
If your DoorHan Gate Opener beeps twice, the door doesn't move, and the display blinks 'P', it indicates that safety devices have been activated. Remove any obstacles and check the operation of the safety devices.
How to fix noise and sagging chain during DoorHan SECTIONAL-1000PRO-CE operation?
If you notice noise and a sagging chain during operation of your DoorHan Gate Opener, it could be due to prolonged use without lubrication. Tighten the chain using the chain-tensioning screw and lubricate the chain.
What to do if the DoorHan Gate Opener door suddenly stopped and the 'F' indicator is on?
If the door has suddenly stopped and the 'F' indicator is on for your DoorHan Gate Opener, it means the door ran into an obstacle. Remove the obstacle, check the door mechanics, or change the pulse sensor.
What does it mean when my DoorHan Gate Opener beeps twice, the door doesn't move, and the display blinks «S»?
If your DoorHan Gate Opener beeps twice, the door doesn't move, and the display blinks 'S', it means the open wicket sensor was activated. If there is no open wicket sensor, check for a jumper in the GND — STOP terminal.
Why did my DoorHan SECTIONAL-1000PRO-CE Gate Opener suddenly stop, and the '?' indicator is on?
If your DoorHan Gate Opener suddenly stopped and the '?' indicator is on, it indicates insufficient supply voltage. Verify that the power supply corresponds to the declared characteristics.
General| Category | Gate Opener |
|---|---|
| Type | Sectional |
| Max. Door Height | 3.5 m |
| Max. Door Weight | 100 kg |
| Motor Voltage | 24 V DC |
| Max. Traction Force | 1000 N |
| Protection Class | IP20 |
| Power | 150 W |
| Control | Remote control, push button |
| Power Supply | 230 V |
Step-by-step instructions for connecting the operator unit to the guide rail, including bushing and bracket installation.
Detailed steps for mounting the track to the lintel and ceiling, including bracket placement and arm attachment.
A visual guide illustrating the connections for photo cells, external control keys, antenna, and motor to the control board.
Instructions for managing remote controls, including adding, deleting, and programming buttons for various functions.
