To Next PageTo Next PageWhat to do if my DoorHan Gate Opener does not run?
If your DoorHan Gate Opener isn't running, there are several potential causes: * **Power Issues:** Ensure that the power is on. * **Obstruction:** Check for and remove any obstructions that may be hindering the gate's movement. * **Wiring:** Examine the electric wiring connections for reliability. * **Operator Release:** Make sure the operator is engaged.
How to fix a DoorHan SWING-3000 Gate Opener that doesn't fully open or close?
If your DoorHan Gate Opener isn't fully opening or closing, it could be due to: * **Limit Switches:** Incorrect adjustment of the limit switches. Adjust them accordingly. * **Operator Programming:** Wrong operator programming. Reprogram the operator.
General| Max. leaf weight | 300 kg |
|---|---|
| Max. leaf width | 3 m |
| Motor voltage | 24 V DC |
| Operating temperature | -30°C to +60°C |
| Protection rating | IP54 |
| Power consumption | 120 W |
| Power supply | 230 V |
| Opening angle | 120 ° |
| Motor type | DC motor |
Defines the load capacity and width limits for the Swing-3000 and Swing-5000 models.
Lists key technical data like weight, voltage, power, protection rating, speed, and force.
Details the standard components provided with the operator unit.
Critical safety advice for installation and operation to prevent personal injury.
Covers installation, usage, electrical safety, and operational precautions for safe use.
Identifies the main parts of the operator unit and their assembly.
Lists the necessary tools for the installation of the gate operator system.
Diagram showing cable routing and placement of components for the gate operator.
Instructions and dimensions for installing the operator for inward opening gates.
Instructions and dimensions for installing the operator for outward opening gates.
Illustrates the wiring connections for the control unit and accessories.
Details the function of each terminal on the control block for power and accessories.
Steps to prepare the operator for adjusting limit switches.
Procedure to set the fully open limit switch for the gate leaf.
Procedure to set the fully closed limit switch for the gate leaf.
Guide to setting fundamental parameters like pause time and motor force.
Details advanced settings for safety devices, indicator lights, and operating modes.
Method for programming the motor's opening and closing times.
Instructions for clearing memory and adding new remote controls to the system.
Steps to release the operator for manual gate operation during power failure.
Recommendations for periodic checks, servicing, and use of spare parts.
Table listing operator problems and their corresponding solutions.
