6004-065-X-2-21
11
Mounting Bracket and Gate Attachment Bracket
Operator Mounting Positions
Attach mounting bracket to pilaster or wall with four (4) #10
screws and suitable expansion hardware (Not supplied).
See next page for specific layout dimensions and page 2 for mounting bracket dimensions.
See next page for specific layout dimensions
and page 2 for operator dimensions.
Mounting Bracket shown in
Left-Side Opening Position.
1 5/8”
MUST be level!
Weld gate attachment bracket to gate or
use two (2) suitable screws (Not supplied).
DOORKING
DOORKING
DOORKING
A support bar must be used if the operator is mounted
in the middle of the gate and typically spans 4 or 5
pickets. The pickets will bend if not supported.
Top
Middle
Bottom
Left-Side Position Right-Side Position
Support Bar
Extreme force will be exerted on
these brackets during gate cycling.
Bottom Installation Note: Make sure that the
operator is mounted high enough off the
ground that it will NOT come in contact with
standing or flowing water. This will damage
the operator.
To Next Page
