Operation Section
53
(4) Water-in-fuel Warning Light (Diesel)
Indicates the fuel contains water. Open
the sensor under the fuel filter to remove
the water.
(5) Front Floodlights
Push down the switch (22), to the first
step, to turn the front floodlights on.
(6) Parking Indicator Light
The light will come ON when the parking
lever is in applied position.
WARNING
Flashing parking indicator lamp (6) warns a
malfunction detected in the charging function
of the brake system which can lead to a
serious accident. Stop the operation and call
the nearest dealer to check up the brake
system.
(7) Transmission Neutral Position Light
Indicates neutral position of the
transmission.
(8) Seat Belt Warning Light
Indicates when the seat belt is not
fastened by operator.
The light will come on when the ignition
switch is turned to ON position.
The light should go off after engine is
started.
(9) Seat Leaving Warning Light
When operator leaves seat without
stopping the engine, hydraulic control
lever will not function.
(10) Engine Check Lamp
The Engine Control System has built-in
fault diagnostics. Detected system faults
can be displayed by the Engine Check
Lamp as Diagnostic Fault Codes (DFC) or
flash codes, and viewed in detail with the
use of service tool software. When the
ignition key is turned ON, the engine
check lamp will perform a self-test,
illuminate once and then go OFF. If a
detected fault condition exists, the fault or
faults will be stored in the memory of the
engine control unit (ECM). After the
ignition key is turned ON and push
acceleration pedal 3times quickly, engine
check lamp will blink as Diagnostic Fault
Codes (DFC) or flash codes. Once a fault
occurs the engine check lamp will light up
and remain ON.
This signals the operator that a fault has
been detected by the ECU.
(11) Directional Turning Indicator Light
Pull the lever to activate the right turn
signal. Push the lever to activate the left
turn signal.
To Next Page
Loading...
