Operation Section
86
IDLE Select Switch (Diesel Only)
This switch controls engine idle speed.
1. When this switch is at "1" position, the engine
idle rpm is increased from 875 (basic speed) to
1600 at a 50 rpm step.
2. At '2' position, the basic condition is maintained.
3. At '3' position, (1.5 sec), the engine idle rpm
returns to 875 (basic speed).
4. With this switch is at '1' position, step on the
accelerator pedal and release the switch, the
engine will keep running at the accelerated
speed.
* To use this function while the engine is running,
set the switch to "3" position to "Open" the
function.
WARNING
If you increase engine rpm with using this
switch, truck creep speed will be faster than
normal mode.
Before change direction lever, press brake pedal
and release smoothly to prevent accident cause
a sudden movement.
Emergency Engine Stop Switch
(Optional)
This switch stops the engine under an emergency
condition.
1. At this position, the engine stops.
2. At this position, the basic condition is maintained.
To Next Page
Loading...
