Doosan DCT2PS - Warning Label Identification; Specific Warnings

WARNING LABEL IDENTIFICATION
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
SPECIFIC WARNINGS
• Whenwearingglovesandoperatingmodelswithinside
trigger, always be sure that the gloves will not prevent
the trigger from being released.
• Wearsafetyshoes,hardhat,safetygoggles,gloves,
dustmask and any other appropriate protective clothing
while operating the tool.
• Donotindulgeinhorseplay.
Distraction can cause accidents.
• Keephandsandfingersawayfromthethrottleleveruntil
it is time to operate the tool.
• Neverrestthetoolorchiselonyourfoot.
• Neverpointthetoolatanyone.
• Compressedairisdangerous.Neverpointanairhoseat
yourself or co–workers.
• Neverblowclothesfreeofdustwithcompressedair.
• Besureallhoseconnectionsaretight.Aloosehosenot
only leaks but can come completely off the tool and while
whipping under pressure, can injure the operator and
others in the area. Attach safety cables to all hoses to
prevent injury in case a hose is accidentally broken.
• Neverdisconnectapressurisedairhose.
Always turn off the air supply and bleed the tool before
disconnecting a hose.
• Theoperatormustkeeplimbsandbodyclearofthe
chisel. If a chisel breaks, the tool with the broken chisel
projecting from the tool will suddenly surge forward.
• Donotridethetoolwithonelegoverthehandle.Injury
can result if the chisel breaks while riding the tool.
• Knowwhatisunderneaththematerialbeingworked.
Be alert for hidden water, gas, sewer, telephone or
electric lines.
• Useonlypropercleaningsolventstocleanparts.
Use only cleaning solvents which meet current safety
and health standards. Use cleaning solvents in a
wellventilated area.
• Donotflushthetoolorcleananypartswithdieselfuel.
Diesel fuel residue will ignite in the tool when the tool is
operated, causing damage to internal parts.
When using models with outside triggers or throttle
levers, take care when setting the tool down to prevent
accidental operation.
• Donotoperatethetoolwithbrokenordamagedparts.
• Neverstartthetoolwhenitislyingontheground.
• Thistoolisnotdesignedforworkinginexplosive
atmospheres.
• Thistoolisnotinsulatedagainstelectricshock.
Always wear eye protection
when operating or performing
maintenance on this tool.
Always wear hearing
protection when operating
this tool.
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable
positions may be harmful to
your hands and arms. Stop
using any tool if discomfort,
tingling feeling or pain occurs.
Seek medical advice before
resuming use.
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
Operate at 90 psig
(6.2 bar/620 kPa)
Maximum air pressure.
Always turn off the air supply
and disconnect the air supply
hose before installing,
removing or adjusting any
accessory on this tool, or
before performing any
maintenance on this tool.
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
Do not carry the tool by
the hose.
17
WARNING WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING