OP000754Operating Controls
2-8
NOTE: Using soapy water or synthetic detergent
instead of window cleaning fluid, may
damage the wiper blade or painted
surfaces. Use standard window cleaning
fluid: SSK703
D. Horn Button - The center button on end of lever
activates horn. (Only while being pressed.)
E. Wiper Switch - Activates wipers when outside area of
lever is rotated.
J: Intermittent Mode - wipes every five seconds.
0: Stop (Off).
I: Normal Speed Mode.
II: High Speed Mode.
F. Push Down - Locks into position and light turns "ON"
the high beams.
G. Neutral Position - Normal low beams.
H. Pull Up - Momentarily turns "ON" both the low beams
and high beams. (Returns to "NEUTRAL" position
when released.)
NOTE: High and low beams will only function with the
headlight switch in the "||" position.
4. Accelerator Pedal
Controls the travel speed of loader and working speed of
load handling system.
Figure 8
F
G
H
HAAA4350
FG003937
Figure 9
CAUTION!
The further the pedal is pressed, the more engine
speed increases. However, do not press the pedal
more than necessary; otherwise it will increase fuel
consumption, cause short life on the engine, and in
the worst case lead to a serious accident.
To Next Page
