DL550-5Transportation
5-4
Unloading
1. Make sure that trailer is parked on firm and level ground.
See Figure 9.
2. Make sure that ramps that are being used are designed to
handle the weight of the machine. If required, add blocking
under the ramp to provide additional support.
3. The ramp angle must be less than a 15° angle. Ramps
steeper than this can cause traction or stability problems
when loading or unloading.
4. Remove wheel chocks and tie down wire cables.
5. Set articulated frame lock to "UNLOCK" position.
6. Turn battery disconnect switch to "ON" direction.
7. Start the engine.
8. Set pilot cutoff switch to "I" (UNLOCKED) position.
9. Set parking brake switch to "O" (DISENGAGED) position.
10. Drive machine slowly for unloading.
To Next Page
