23
Harnessed mode: Installing the seat in your vehicle
1. Loosen the top tether strap. Place restraint on
back seat of vehicle in line with a top tether
strap anchorage point.
2. Hold the lap-sash belt together and start under
the armrest. Feed the lap-sash belt through the
front of the seat, through the YELLOW forward-
facing belt path.
3. Place your hand behind the seat and pull the
belt across the back.
4. Feed the lap-sash belt through the opening in
the back of the seat, marked as the YELLOW
forward-facing belt path.
5. Fasten the seatbelt, ensuring you hear
a ‘CLICK’.
6. Reposition the sash-belt from the outside of
the seat to the inside. The sash-belt should lay
as shown as pictured.
NOTE: Before you start installation, adjust
the shoulder straps to t your child.
Refer to page 19.
PUSH
CLICK
BEHIND
SEAT
LOOSEN TETHER
To Next Page
Loading...
