32
Care and maintenance
CLEANING COVERS AND HEADREST
HEADREST COVER: Adjust the booster seat headrest to its highest position.
Separate velcro from around sash guides and back of headrest to remove cover.
MAIN BODY COVER: Separate velcro at the back of the seat. Pull around the
armrest and remove cover off the seat. Ensure you free the elastic under seat and
that it is not caught on cup holders.
• The seat covers can be machine washed in lukewarm water on the ‘delicate’ cycle.
• Tumble dry for 10 - 15 minutes on low heat.
• DO NOT BLEACH
• DO NOT DRY CLEAN
• DO NOT IRON
• Once they are fully dry, they should be retted in the following sequence:
FITTING THE MAIN BODY COVER
Start by tting on the armrest, then place the trim on
the back. Pull elastic under the base and over the cup
holders, then fasten the velcro under the base and on
the back of the trim.
FITTING THE HEADREST COVER
Extend the booster seat headrest to its highest position
then t the headrest cover by stretching it over the head-
rest and securing velcro tabs around the sash guide.
To Next Page
Loading...
