Dorgard DG1328-FP - Beep and LED Messages Explained

English
Beep and LED Messages Explained continued
Beep / Flash Sequence What it means What to do
During standard operation
LoHi – LoHI – LoHi – LoHi – LoHi – LoHi –LoHi – LoHi Dorgard resetting ready No action required
*--------*--------*--------*--------*--------*--------*--------* for re-activation
Tone and flash sequence Is followed by the sound
of the motor driving
Error Modes
Lo – (2secs) – Lo – (2secs) – Lo – (2secs) – etc Indicates battery lift is not 1) Screw down battery lift
*----------*----------*----------*----------*----------etc screwed down properly
HiHiLo………………… Possible fault with motor 1) Check ferrule is not worn
This pattern may repeat or damaged. Replace if
* * *…………………… necessary
2)Release tension on fixing
screws and check Dorgard
is positioned flat against
door with no obstructions
3)Recycle or if necessary,
replace batteries
HiHiHiHiLoLoLoLo---(4secs)--- Indicates possible plunger Same 3 points of action
HiHiHiHiLoLoLoLo---(4secs)---etc movement fault as above
HiLoLoLo---(4secs)---HiLoLoLo---(4secs)---etc Indicates possible problem Same 3 points of action
* * * * -------(4secs)--- * * * * -------(4secs)--- etc with battery insertion as above
HiLo-------(17mins)------HiLo------(17mins)------etc Low battery mode or Same 3 points of action
(Dorgard will repeat HiLo 8 times after 68mins) miscellaneous error as above
****--(4secs)-- ****--(4secs)-- ****--(4secs)-- etc
* LED flash
11
Fit&OpGuideINTERNATIONAL 23/7/04 2:20 pm Page 13