Doro th50 - Expanded system (+1); Intercom; internal call; Transferring calls;Conference between handsets; Troubleshooting

12
English
Expanded system (+1)
All handsets included in the package are already registered to the base unit. The
handset number used for internal calls is shown in the display on standby mode.
The base unit should be positioned centrally so that the coverage area is roughly equal for
all handsets.
You can register up to 5 handsets to one base unit.
This model is GAP (Generic Access Prole) compatible, which means that the handset and the base unit can
both be used with most other GAP compatible units irrespective of manufacturer. However the GAP protocol
cannot guarantee that all functions may be accessed.
Intercom / internal call
1. Press Int.
2. Scroll to selected handset. Press OK.
Atonewillbeheardifanexternalcallcomesinwhileaninternalcallisinprogress.End
the internal call with
L
andthenanswertheexternalcallwith
O
.
Transferring calls/Conference between handsets
1. Anexternalcallisconnected.
2. Initiate an internal call as described above.
3. Press
L
to transfer the call or press Conf for conference.
Troubleshooting
Check that the telephone cord is undamaged and properly plugged in. Disconnect any
additionalequipment,extensioncordsandotherphones.Iftheproblemisresolved,the
fault is with some other equipment.
Testtheequipmentonaknownworkingline(e.g.ataneighbour’shouse).Iftheequipmentworks
there the fault is probably with your telephone line. Please report this to your network operator.
No number shown when ringing
- This function requires a Caller ID subscription from your service provider.
- A switchboard cannot usually pass on incoming numbers.
Warning signal during call/Cannot connect
- Thebatteriesmayberunninglow(rechargethehandunit).
- The hand unit may be nearly out of range. Move closer to a base unit.
- Try turning the ECO Mode function off under System settings.
Telephone does not work
- Check that the adapter and telephone cord are connected to the base unit and to their
respective wall sockets.
- Check that you have selected Tone Dial, see System Settings/Dial.
- Check the charge status of the handset batteries.
- Try connecting another telephone, known to be in working order, to the line socket.
If that phone works then it is likely that this equipment is faulty.