On these larger stumps, DO NOT allow grinder wheels to drop into stump hole. If a hole
is in the way of your progress, fill it with chips or change position.
WARNING:
Stop engine and set brake before leaving operator’s position. KEEP
BRAKE ENGAGED except when changing locations.
10. When finished, stop the machine.
11. Pull machine away from stump, and rake chips away from stump.
1) Before removing gas cap, turn engine off and allow to cool for at least two minutes.
Note: A running or hot engine can ignite fuel.
2) Remove grinder gasoline cap.
3) Add gasoline through the fill opening:
- Use only an UL-approved portable gasoline container to transfer the gasoline to the grinder’s
tank.
- Be aware of safety warning and instructions below for avoiding static electric caused fires.
WARNING:
Static electric spark hazard
A static electric spark can explosively ignite gasoline vapor,
resulting in a flash fire that could cause serious injury or death.
See “Special Safety Information on Static Electricity” at end of
this manual.
4) Clean up gasoline spills /splashes immediately.
If possible, move the grinder away from spilled gasoline on
the ground.
Wipe up spilled gasoline, and wait 5 minutes for excess
gasoline to evaporate before starting engine.
Gasoline soaked rags are flammable and should be disposed
of properly.
If gasoline is spilled on your skin or clothes, change clothes
To Next Page
Loading...
