DoubleSight DS-263N - Page 7

Display Controls Display Controls
 
Function Description
Function Description
Information
Input Select
OSD Warnings
NO SIGNAL
OSD Warnings
OUT OF RANGE
Provide information about resolution, H/V frequencies,
and polarity of the input signal.
This function gives warning about input resolution or
refresh rate that the monitor cannot display.
If video signal is not at the proper timing when the
monitor powers on or input signal is changed, this
message opens and it disappears after 45 seconds,
or by "EXIT" key.
-D
ANALOG INPU
T
-D
Input Select
DVI ANALOG
D-SUB INPUT
NO SIGNAL
DVI-D
NO SIGNAL
DVI INPUT
NO SIGNAL
DVI ANALOG
NO SIGNAL
D-SUB INPUT
OUT OF RANGE
DVI-D
OUT OF RANGE
DVI INPUT
OUT OF RANGE
DVI ANALOG
OUT OF RANGE
RESOLUTION
NOTIFIER Factory setting: OFF