Dover Markem-Imaje 1050 User Manual (English)

Other manuals for Dover Markem-Imaje 1050

Questions and Answers:

M
Mary WallsAug 7, 2025
Why does my Dover Printer stop while printing?
- C
  Carla JonesAug 7, 2025
  If your Dover Printer stops while printing, it could be due to several reasons. Here are a few things to check: * The direction of travel for the pen may not be set correctly. Remember, this direction is determined by looking down at the top of the cartridge from the back. * The target might be too far from the pen. Ensure the distance is approximately 1/8” (3mm) or less. * The transport might be moving too fast. The maximum speed should be 333 ft/min at 300 DPI. * The print controller may have stopped responding. If it loses power, connectivity, or fails, the printer will halt. * A pen cartridge may have failed. If any connected pen fails after the print job starts, an error code will be printed, and printing will stop.
J
Jennifer RiversAug 15, 2025
Why is the print quality poor on my Dover Printer?
- K
  kschmidtAug 16, 2025
  Poor print quality on your Dover Printer can stem from several factors. Here's what to investigate: * Verify the encoder settings in the Printer configuration and check to make sure encoder wheel is connected and turning. An improperly connected or configured encoder can cause issues. * Check that the edge sensor is triggering correctly. A faulty or disconnected edge sensor can affect quality. * In the Printer Configuration window under advanced settings ensure that the voltage and fire time are not too low. Invalid cartridges can lead to poor output. * Print nozzles can become clogged if the printer is idle and the cartridge is not capped. Addressing these points should help improve your print quality.
S
sherrysuarezAug 27, 2025
What to do if my Dover Printer starts, but no images print?
- L
  Louis WintersAug 27, 2025
  If your Dover Printer starts but produces no images, here are a few potential causes: * Make sure the printer is powered on. * Verify that at least one pen with a print cartridge is available. * Run print preview for the job to make sure the images are not blank. The job may not have printable objects. * Clean the cartridge and replace if necessary. The pen cartridge nozzles may be clogged.

Dover Markem-Imaje 1050 Specifications

General

Print Technology	Thermal Transfer
Technology	Thermal Transfer
Print Speed	Intermittent: Up to 600 mm/s; Continuous: Up to 1000 mm/s
Print Resolution	300 dpi
Connectivity	USB, Ethernet
Supported Materials	Labels